Performing Programmable Memory Scan - Yaesu FTM-400DR Operating Manual

Performing Programmable Memory Scan

The programmable memory allows you to scan the specified frequency range in the
same frequency band.
1
Switch to Memory mode.
Recall the PMS memory storing the lower limit
frequency or upper limit frequency.
2
Press F shortly.
3
Tap [SCAN].
Programmable memory scanning starts.
Reference • Pressing and holding [UP] or [DOWN] over 1
second also starts scanning.
• When a signal is received during scanning, scanning pauses for 5 seconds.
• The scanning resumes 5 seconds after signal has been received.
• To cancel scanning, tap [SCAN] or [PTT] on the microphone.
Precaution
When the lower/upper limit frequency is not properly specified, program memory scanning is not
performed properly.
Reference
• If PMS memory channels have already been assigned to L1/U1 to L9/U9, selecting a PMS number
in the VFO scanning procedure described on page 56 allows you to skip step 1 described above.
• When a skip memory (
not properly specified, program memory scanning is not performed properly.
• Even during scanning, you can adjust the squelch in the following procedure:
Tap [SQL] → Adjust squelch with v → Tap [SQL]
) is specified for "L " or "U " or when the lower/upper limit frequency is
FCC ID:
IC:
Using the Scanning Function
K6620345X40
511B-20345X40
39