Skipping Unwanted Scan Frequencies (Skip Search Memory); Programmable Memory Channel Scan (Pms); Registering To The Programmable Memory Channels; Performing Programmable Memory Channel Scan - Yaesu FT5Dr Advance Manual

Skipping Unwanted Scan Frequencies (Skip Search Memory)

During the VFO scan, an unwanted frequency may be skipped by registering it to the "skip
search memory channels" in advance.
z Set the temporary scan stop to the skip search memory
1. Press and hold the [V/M • ] key to temporarily stop the VFO scan.
2. Rotate the DIAL knob to select a skip search memory channel from 901-999.
Only skip search memory channels 901-999 may be selected.
3. Press the [V/M • ] key.
The beep sounds, and the search skip channel is saved to memory, then the scan
resumes.
z Specifying Unwanted VFO Scan Frequencies
1. In the VFO mode, set the frequency that you do not want to receive.
2. Register the skip search memory (901-999) with the same steps as "Registering to
Memory Channels" (see the Operating Manual).
The skip search memory may be deleted with the same steps as "Clearing Memories" (see
the Operating Manual). The deleted frequency is scanned again.

Programmable Memory Channel Scan (PMS)

Registering to the Programmable Memory Channels

50 sets of PMS memory channels (L1/U1 to L50/U50) are available.
• Register the lower and upper frequencies of the frequency range in a pair of
Programmable Memory Channels.
L ££ ： Lower limit memory channel
U ££ ： Upper limit memory channel
• For more details on registering frequencies to the memory channel, refer to the
"Registering to Memory Channels" in the Operating Manual.
• Make sure to use the corresponding numbers for the lower and upper limit memory
channels.
• Set the PMS memory channel for performing the Programmable Memory scanning (PMS)
as follows:
• The scan width of the upper and lower limit frequencies must be 100 kHz or more.
• The lower and upper limit memory channels must be within the same frequency band.
• The lower and upper limit memory channels must not be registered in reverse.
• The PMS memory channel must not be registered as a skip memory channel.

Performing Programmable Memory Channel Scan

The programmable memory channel scan allows scanning a specified frequency range
within the same frequency band.
1. Recall the PMS memory channel to which the lower limit (L ££ ) or upper limit (U ££ )
of the frequency band is registered.
2. Press the [F
MENU
• If [SCAN] is not displayed, touch [BACK ←] to display [SCAN] and then touch it.
• Programmable memory channel scanning starts.
• During scanning, "PMSP ££ " appears on the upper left side of the display.
• If the DIAL knob is rotated while scanning is in progress, the scanning will continue
up or down in frequency according to the direction of the DIAL Knob rotation.
] key  [SCAN].
22