Selecting A Reception Method When Scanning Stops; Memory Scanning - Yaesu FT1DR Operating Manual

Selecting a Reception Method When Scanning Stops

When scanning stops, you can select one of the following three reception methods:
(1) The signal is received for the specified period of time, and then scanning resumes.
You can specify this period of time in steps of 0.5 second within the range from 2
seconds to 10 seconds.
(2) The signal is received until it fades out. Two seconds after the signal fades out,
scanning resumes. "BUSY" is displayed on the LCD.
(3) Scanning stops and the current frequency is received. "HOLD" is displayed on the
LCD.
Press the M key more than 1 second.
1
Turn the O knob to select "5 SCAN".
2
Press the M key briefly.
3
Turn the O knob to select "4 SCAN RESUME".
4
Press the M key briefly.
5
Turn the O knob to select a reception method.
6
Select a reception method from "2 SEC TO 10 SEC (0.5 SEC STEP)", "BUSY", and
"HOLD".
Press the M key more than 1 second.
7
The selected reception method is determined.
Press the M key more than 1 second again.
8
The Set mode is canceled.
Hints
• The reception method selected here is also applied to "VFO Scanning", "Programmable Memory
Scanning", and "Dual Reception".
• The "BUSY" scanning start time can be changed by selecting the Set mode item "3 SCAN
RE-START".

Memory Scanning

Frequencies saved in the memory can be scanned in the order of memory channel
number.
1
Select the Memory mode, and recall memory channel.
While pressing the B key, turn the O knob to specify
2
the scanning range.
Specify the scanning range with reference to the table on
the next page.
FCC ID: K6620445X20
IC: 511B-20445X20
Using the Scanning Function
While the B key is
pressed down, the scanning
range is displayed.
When a signal is received,
the decimal point blinks.
YAESU MUSEN
51
CO., LTD.