Using the Scanning Function
The FTM-400DR supports the following four scan modes:
(1) VFO Scan
(2) Memory Scan
(3) Programmable Memory Scan
(4) Selected Memory Channel Scan
VFO Scan
1
Switch to the VFO mode, and then select a band to scan.
2
Press F shortly.
The Function Menu appears.
3
Tap [SCAN].
Scanning (SCAN) starts toward higher frequencies.
Reference
• Pressing and holding [UP] or [DOWN] over 1
second also starts scanning.
• When a signal is received during scanning,
a beep is emitted and scanning pauses for 5
seconds and then resumes.
• The scan direction (HIGH/LOW) can be set in the
[SCAN] → [2 SCAN DIRECTION] of the Setup
Menu.
• The operation to perform when scanning stops
can be set in the [SCAN] → [3 SCAN RESUME] of the Setup Menu.
Canceling Scanning
To chancel scanning, tap [SCAN] or [PTT] on the microphone.
Reference
• For the operation to perform when scanning stops, see "Setting a Reception Method When
Scanning Stops" on page (See page 000).
Setting a Reception Method When Scanning Stops
When scanning stops, you can select one of the following three reception methods:
(1) The signal is received for the specified period of time, and then scanning resumes.
You can specify this period of time to 1 second, 3 seconds, or 5 seconds.
(2) The signal is received until it fades out. Two seconds after the signal fades out,
scanning resumes. "BUSY" appears on screen.
(3) Scanning stops and the current frequency is received. "HOLD" appears on screen.
34
Scanning Function
FCC
ID:
K6620345X40
IC:
511B-20345X40