Toggling The Operating Band; Selecting A Frequency Band; Tuning To A Frequency - Yaesu FT3DR Operating Manual

Toggling the Operating Band

Normally, both operating bands are displayed on the top
half and bottom half of the transceiver touch screen. This
is Dual band.
With one of the bands selected, change the frequency and
radio operating mode.
• The selected band (displayed in white letters) is called
Operating band.
• The other band (displayed in gray letters) is called Sub-
band.
• Each time pressing the [A/B] key toggles the operating
band.
• The desired operating band may also be selected by
touching the frequency display.
Pressing and hold the [A/B] key displays only the operating
band, this is Mono-band.

Selecting a Frequency Band

1. Press the [BAND] key to select the desired fre-
quency band.
• Press the [F MW] key, then press the [BAND] key
to switch the frequency bands in reverse order.

Tuning to a Frequency

● DIAL knob
By pressing the ［ F MW］ key and then rotating the
DIAL knob, the frequency will change in 1 MHz steps.
14