Configuration Prerequisites; Enabling Ipv6 Pim - HP 4800G Series Configuration Manual

Configuring a BSR
Configuring IPv6 Multicast Source Registration
Disabling SPT Switchover
Configuring IPv6 PIM Common Features

Configuration Prerequisites

Before configuring IPv6 PIM-SM, complete the following task:
Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SM, prepare the following data:
The IP address of a static RP and an ACL rule defining the range of IPv6 multicast groups to be
served by the static RP
C-RP priority and an ACL rule defining the range of IPv6 multicast groups to be served by each
C-RP
A legal C-RP address range and an ACL rule defining the range of IPv6 multicast groups to be
served
C-RP-Adv interval
C-RP timeout
C-BSR priority
Hash mask length
An IPv6 ACL rule defining a legal BSR address range
BS period
BS timeout
An IPv6 ACL rule for register message filtering
Register suppression time
Register probe time
The IPv6 ACL rule and sequencing rule for SPT switchover
Enabling IPv6 PIM-SM
With IPv6 PIM-SM enabled, a router sends hello messages periodically to discover IPv6 PIM neighbors
and processes messages from the IPv6 PIM neighbors. When deploying an IPv6 PIM-SM domain, you
are recommended to enable IPv6 PIM-SM on all non-border interfaces of the routers.
Follow these steps to enable IPv6 PIM-SM:
To do...
Enter system view
Task
Configuring C-RP timers globally
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Configuring C-BSR parameters globally
Configuring C-BSR timers
Use the command...
system-view
1-17
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
—