Displaying And Maintaining Traffic Accounting - HP 4800G Series Configuration Manual

Displaying and Maintaining Traffic Accounting

After completing the configuration above, you can verify the configuration with the display qos policy
global, display qos policy interface, or display qos vlan-policy command depending on the
occasion where the QoS policy is applied.
Class-Based Accounting Configuration Example
Class-Based Accounting Configuration Example
Network requirements
As shown in Figure
Configure class-based accounting to collect statistics for traffic sourced from 1.1.1.1/24 and received on
GigabitEthernet 1/0/1.
Figure 11-1 Network diagram for traffic accounting configuration
Configuration procedure
# Create basic ACL 2000, and configure a rule to match packets with source IP address 1.1.1.1.
<DeviceA> system-view
[DeviceA] acl number 2000
[DeviceA-acl-basic-2000] rule permit source 1.1.1.1 0
[DeviceA-acl-basic-2000] quit
# Create a class named classifier_1, and reference ACL 2000 in the class.
[DeviceA] traffic classifier classifier_1
[DeviceA-classifier-classifier_1] if-match acl 2000
[DeviceA-classifier-classifier_1] quit
# Create behavior behavior_1, and configure an accounting action in the behavior.
[DeviceA] traffic behavior behavior_1
[DeviceA-behavior-behavior_1] accounting
[DeviceA-behavior-behavior_1] quit
# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the
policy.
[DeviceA] qos policy policy
[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1
[DeviceA-qospolicy-policy] quit
# Apply the policy named policy to the incoming traffic of GigabitEthernet 1/0/1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] qos apply policy policy inbound
11-1, Host is connected to GigabitEthernet 1/0/1 of Device.
11-2