Follow these steps to configure an OSPFv3 cost for an interface:
To do...
Enter system view
Enter interface view
Configure an
OSPFv3 cost for the
interface
Follow these steps to configure a bandwidth reference value:
To do...
Enter system view
Enter OSPFv3 view
Configure a bandwidth
reference value
Configuring the Maximum Number of OSPFv3 Load-balanced Routes
If multiple equal-cost routes to a destination are available, enabling load balancing among these routes
can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do...
Enter system view
Enter OSPFv3 view
Specify the maximum number
of load-balanced routes
Configuring a Priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
Follow these steps to configure a priority for OSPFv3:
To do...
Enter system view
Enter OSPFv3 view
Use the command...
system-view
interface interface-type
interface-number
ospfv3 cost value
[ instance instance-id ]
Use the command...
system-view
ospfv3 [ process-id ]
bandwidth-reference value
Use the command...
system-view
ospfv3 [ process-id ]
maximum load-balancing
maximum
Use the command...
system-view
ospfv3 [ process-id ]
1-9
Remarks
—
—
Optional
By default, OSPFv3 computes an interface's
cost according to its bandwidth.
The cost value defaults to 1 for VLAN interfaces
of switches and defaults to 0 for loopback
interfaces.
—
—
Optional
100 Mbps by default
—
—
Optional
4 by default.
—
—
Remarks
Remarks
Remarks