Configuring Static Ports - HP 4800G Series Configuration Manual

To do...
Configure dynamic member
port aging time
Configuring aging timers for dynamic ports in a VLAN
Follow these steps to configure aging timers for dynamic ports in a VLAN:
To do...
Enter system view
Enter VLAN view
Configure dynamic router port
aging time
Configure dynamic member
port aging time

Configuring Static Ports

If all the hosts attached to a port are interested in the multicast data addressed to a particular multicast
group or the multicast data that a particular multicast source sends to a particular group, you can
configure static (*, G) or (S, G) joining on that port, namely configure the port as a group-specific or
source-and-group-specific static member port.
You can configure a port of a switch to be a static router port, through which the switch can forward all
the multicast traffic it received.
Follow these steps to configure static ports:
To do...
Enter system view
Enter Ethernet port/Layer 2
aggregate port view or port
group view
Configure the port(s) as static
member port(s)
Configure the port(s) as static
router port(s)
Use the command...
host-aging-time interval
Use the command...
system-view
vlan vlan-id
igmp-snooping
router-aging-time interval
igmp-snooping
host-aging-time interval
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
igmp-snooping static-group
group-address [ source-ip
source-address ] vlan vlan-id
igmp-snooping
static-router-port vlan vlan-id
1-9
Remarks
Optional
260 seconds by default
Remarks
—
—
Optional
105 seconds by default
Optional
260 seconds by default
Remarks
—
Required
Use either approach
Required
No static member ports by
default
Required
No static router ports by default