Ospf Configuration Examples; Configuring Ospf Basic Functions - HP 4800G Series Configuration Manual

To do...
Reset an OSPF process
Re-enable OSPF route
redistribution

OSPF Configuration Examples

These examples only cover commands for OSPF configuration.

Configuring OSPF Basic Functions

Network requirements
As shown in the following figure, all switches run OSPF. The AS is split into three areas, in which,
Switch A and Switch B act as ABRs to forward routing information between areas.
After configuration, all switches can learn routes to every network segment in the AS.
Figure 1-21 Network diagram for OSPF basic configuration
Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configure OSPF basic functions
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] area 1
Use the command...
reset ospf [ process-id ] process
[ graceful-restart ]
reset ospf [ process-id ] redistribution
1-46
Remarks