Enabling Message Logging; Enabling The Advertisement And Reception Of Opaque Lsas; Configuring Ospf To Give Priority To Receiving And Processing Hello Packets; Configuring The Lsu Transmit Rate - HP 4800G Series Configuration Manual

Enabling Message Logging

Follow these steps to enable message logging:
To do...
Enter system view
Enter OSPF view
Enable message
logging

Enabling the Advertisement and Reception of Opaque LSAs

With this feature enabled, the OSPF router can receive and advertise Type 9, Type 10 and Type 11
opaque LSAs.
Follow these steps to enable the advertisement and reception of opaque LSAs:
To do...
Enter system view
Enter OSPF view
Enable the advertisement and
reception of opaque LSAs

Configuring OSPF to Give Priority to Receiving and Processing Hello Packets

To ensure OSPF runs normally, a router receives and processes Hello packets and other protocol
packets at the same time. When the router has established neighbor relationships with multiple
neighboring routers and the routing table size is big, the router will need to receive and process large
numbers of packets. Configuring OSPF to give priority to receiving and processing Hello packets helps
ensure stable neighbor relationships.
Follow these steps to configure OSPF to give priority to receiving and processing Hello packets:
To do...
Enter system view
Configure OSPF to give priority to
receiving and processing Hello
packets

Configuring the LSU Transmit Rate

Sending large numbers of LSU packets for LSDB synchronization with neighbors may affect router
performance and consume large network bandwidths. Therefore, you can configure the router to send
LSU packets at a proper interval and limit the maximum number of LSU packets sent out an OSPF
interface each time.
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
enable log [ config | error | state ]
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
opaque-capability enable
Use the command...
system-view
ospf packet-process
prioritized-treatment
1-40
Remarks
—
—
Required
Not enabled by default.
Remarks
—
—
Optional
Disabled by default
Remarks
—
Required
Not configured by default.