Configuring Attributes Related To Data To Be Sent To The Radius Server - HP 4800G Series Configuration Manual

If both the primary server and the secondary server are in the blocked state, it is necessary to
manually turn the secondary server to the active state so that the secondary server can perform
authentication. If the secondary server is still in the blocked state, the primary/secondary
switchover cannot take place.
If one server is in the active state while the other is blocked, the primary/secondary switchover will
not take place even if the active server is not reachable.
The server status set by the state command cannot be saved in the configuration file and will be
restored to active every time the server restarts.

Configuring Attributes Related to Data to Be Sent to the RADIUS Server

Follow these steps to configure the attributes related to data to be sent to the RADIUS server:
To do...
Enter system view
Enable the RADIUS trap
function
Create a RADIUS scheme and
enter RADIUS scheme view
Specify the format of the
username to be sent to a
RADIUS server
Specify the unit for data flows
or packets to be sent to a
RADIUS server
Set the
source IP
address of the
device to
send RADIUS
packets
Use the command...
system-view
radius trap
{ accounting-server-down |
authentication-server-down }
radius scheme
radius-scheme-name
user-name-format
{ keep-original | with-domain |
without-domain }
data-flow-format { data { byte
| giga-byte | kilo-byte |
mega-byte } | packet
{ giga-packet | kilo-packet |
mega-packet | one-packet } }*
In RADIUS
nas-ip ip-address
scheme view
quit
In system view
radius nas-ip ip-address
1-27
Remarks
—
Optional
Disabled by default
Required
Not defined by default
Optional
By default, the ISP domain
name is included in the
username.
Optional
The defaults are as follows:
byte for data flows, and
one-packet for data packets.
Use either command
By default, the outbound port
serves as the source IP
address to send RADIUS
packets