HP 4800G Series Configuration Manual page 740

[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
# Create VLAN 10, add GigabitEthernet 1/0/10 to VLAN 10, and create VLAN-interface 10.
[MCE-vpn-instance-vpn2] quit
[MCE] vlan 10
[MCE-vlan10] port GigabitEthernet 1/0/10
[MCE-vlan10] quit
[MCE] interface Vlan-interface 10
# Bind VLAN-interface 10 to VPN1, and configure IP address 10.214.10.3/24 for VLAN-interface 10.
[MCE-Vlan-interface10] ip binding vpn-instance vpn1
[MCE-Vlan-interface10] ip address 10.214.10.3 24
# Create VLAN 20, add GigabitEthernet 1/0/20 to VLAN 20, create VLAN-interface 20, bind
VLAN-interface 20 to VPN2, and configure IP address 10.214.20.3/24 for VLAN-interface 20.
[MCE-Vlan-interface10] quit
[MCE] vlan 20
[MCE-vlan20] port GigabitEthernet 1/0/20
[MCE-vlan20] quit
[MCE] interface Vlan-interface 20
[MCE-Vlan-interface20] ip binding vpn-instance vpn2
[MCE-Vlan-interface20] ip address 10.214.20.3 24
[MCE-Vlan-interface20] quit
# Create VLAN 30, VLAN 40 and the corresponding VLAN interfaces. Then bind VLAN 30 to VPN 1,
and VLAN 40 to VPN 2, and configure IP addresses of the VLAN interfaces.
[MCE] vlan 30
[MCE-vlan30] quit
[MCE] interface Vlan-interface 30
[MCE-Vlan-interface30] ip binding vpn-instance vpn1
[MCE-Vlan-interface30] ip address 10.214.30.1 30
[MCE-Vlan-interface30] quit
[MCE] vlan 40
[MCE-vlan40] quit
[MCE] interface Vlan-interface 40
[MCE-Vlan-interface40] ip binding vpn-instance vpn2
[MCE-Vlan-interface40] ip address 10.214.40.1 30
[MCE-Vlan-interface40] quit
Configure the routing protocol running between MCE and a site
MCE is directly connected to VPN1, which has no routing protocol enabled. You can configure to use
static routes between MCE and a site.
Configuration on VR1: Assume VR1 is an Switch 4800G, configure IP address 10.214.10.2/24 for the
interface connecting to MCE and IP address 192.168.0.1/24 for the interface connecting to VPN1. The
operation of adding a port to a VLAN and configuring IP address for a VLAN-interface is omitted here.
# Configure a default route on VR1, specifying the next hop address to 10.214.10.3.
<VR1> system-view
[VR1] ip route-static 0.0.0.0 0.0.0.0 10.214.10.3
2-14