Mld Proxying Configuration Example - HP 4800G Series Configuration Manual

UpTime: 00:13:25
Upstream interface: Vlan-interface103
Upstream neighbor: 3002::1
RPF prime neighbor: 3002::1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface400

MLD Proxying Configuration Example

Network requirements
IPv6 PIM-DM is required to run on the core network. Host A and Host C in the stub network receive
VOD information destined to multicast group FF3E::101.
It is required to configure the MLD proxying feature on Switch B so that Switch B can maintain
group memberships and forward IPv6 multicast traffic without running IPv6 PIM-DM.
Network diagram
Figure 1-9 Network diagram for MLD proxying configuration
Configuration procedure
1) Enable IPv6 forwarding and configure the IPv6 addresses
Enable IPv6 forwarding on each switch and configure the IPv6 address and prefix length of each
interface as per
2) Enable IPv6 multicast routing, IPv6 PIM-DM, MLD, and MLD proxying respectively.
# Enable IPv6 multicast routing on Switch A, IPv6 PIM-DM on VLAN-interface 101, and MLD on
VLAN-interface 100.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 dm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
Protocol: mld, UpTime: 00:13:25, Expires: never
Figure 1-9. The detailed configuration steps are omitted here.
1-26