HP 4800G Series Configuration Manual page 693

To do...
Configure the router as a route
reflector and specify an IPv6
peer/peer group as a client
Enable route reflection
between clients
Configure the cluster ID of the
route reflector
In general, since the route reflector forwards routing information between clients, it is not required
to make clients of a route reflector fully meshed. If clients are fully meshed, it is recommended to
disable route reflection between clients to reduce routing costs.
If a cluster has multiple route reflectors, you need to specify the same cluster ID for these route
reflectors to avoid routing loops.
Use the command...
peer { ipv6-group-name |
ipv6-address } reflect-client
reflect between-clients
reflector cluster-id cluster-id
1-18
Remarks
Required
Not configured by default.
Optional
Enabled by default.
Optional
By default, a route reflector
uses its router ID as the cluster
ID