Configuring Static Joining - HP 4800G Series Configuration Manual

Configuring an MLD version globally
Follow these steps to configure an MLD version globally:
To do...
Enter system view
Enter MLD view
Configure an MLD version
globally
Configuring an MLD version on an interface
Follow these steps to configure an MLD version on an interface:
To do...
Enter system view
Enter interface view
Configure an MLD version on
the interface

Configuring Static Joining

After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast
source and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast
data addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
Follow these steps to configure a static member of an IPv6 multicast group or an IPv6 multicast source
and group:
To do...
Enter system view
Enter interface view
Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group
Use the command...
system-view
mld
version version-number
Use the command...
system-view
interface interface-type
interface-number
mld version version-number
Use the command...
system-view
interface interface-type
interface-number
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
1-11
Remarks
—
—
Optional
MLDv1 by default
Remarks
—
—
Optional
MLDv1 by default
Remarks
—
—
Required
By default, an interface is not a
static member of any IPv6
multicast group or IPv6
multicast source and group.