HP 4800G Series Configuration Manual page 868

Network diagram
Figure 1-13 Network diagram for PIM-SSM configuration
Device Interface
Switch A Vlan-int100
Vlan-int101
Vlan-int102
Switch B Vlan-int200
Vlan-int103
Switch C Vlan-int200
Vlan-int104
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Configure the OSPF protocol for interoperation among the switches in the PIM-SM domain. Ensure the
network-layer interoperation in the PIM-SM domain and enable dynamic update of routing information
among the switches through a unicast routing protocol. Detailed configuration steps are omitted here.
2) Enable IP multicast routing, and enable PIM-SM and IGMP
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and run IGMPv3 on
VLAN-interface 100, which connects Switch A to the stub network.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] igmp version 3
[SwitchA-Vlan-interface100] pim sm
IP address Device
10.110.1.1/24 Switch D
192.168.1.1/24
192.168.9.1/24
10.110.2.1/24 Switch E
192.168.2.1/24
10.110.2.2/24
192.168.3.1/24
1-52
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24
Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.2/24
Vlan-int102 192.168.9.2/24
Vlan-int105 192.168.4.1/24
Figure 1-13. Detailed configuration