Advertising A Default Route To An Ipv4 Mbgp Peer Or Peer Group; Configuring Outbound Mbgp Route Filtering - HP 4800G Series Configuration Manual

Configure
MBGP route
summarization

Advertising a Default Route to an IPv4 MBGP Peer or Peer Group

Follow these steps to advertise a default route to an MBGP peer or peer group:
To do...
Enter system view
Enter BGP view
Enter IPv4 MBGP address
family view
Advertise a default route to an
MBGP peer or peer group
With the peer default-route-advertise command executed, the router sends a default route with the
next hop being itself to the specified MBGP peer or peer group, regardless of whether the default route
is available in the routing table.

Configuring Outbound MBGP Route Filtering

If several filtering policies are configured, they are applied in the following sequence:
filter-policy export
peer filter-policy export
peer as-path-acl export
peer ip-prefix export
peer route-policy export
Only the routes that have passed all the configured policies can be advertised.
To do...
Enable automatic
route
summarization
Configure manual
route
summarization
system-view
bgp as-number
ipv4-family multicast
peer { group-name | ip-address }
default-route-advertise
[ route-policy route-policy-name ]
Use the command...
summary automatic
aggregate ip-address { mask |
mask-length } [ as-set | attribute-policy
route-policy-name | detail-suppressed |
origin-policy route-policy-name |
suppress-policy route-policy-name ] *
Use the command...
1-5
Remarks
Required
No route
summarization
is configured by
default.
Choose either
as needed; if
both are
configured, the
manual route
summarization
takes effect.
Remarks
—
—
—
Required
Not advertised by default