HP 4800G Series Configuration Manual page 862

Network diagram
Figure 1-12 Network diagram for PIM-SM admin-scope zone configuration
Admin-scope 1
Receiver
Host A
Vlan-int100
Vlan-int101
Switch A
Switch I
Vlan-int110
Vlan-int110
PIM-SM
Global-scope
Device Interface
Switch A Vlan-int100
Vlan-int101
Switch B Vlan-int200
Vlan-int101
Vlan-int103
Vlan-int102
Switch C Vlan-int300
Vlan-int104
Vlan-int105
Vlan-int103
Vlan-int106
Switch H Vlan-int110
Vlan-int106
Switch I Vlan-int600
Vlan-int110
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per
configuration steps are omitted here.
Configure OSPF for interoperation among the switches in the PIM-SM domain. Ensure the
network-layer interoperation among the switches in the PIM-SM domain and enable dynamic update of
routing information among the switches through a unicast routing protocol. Detailed configuration steps
are omitted here.
Source 1
Vlan-int200
Vlan-int102
Vlan-int101
Switch B
ZBR
Switch H
Vlan-int106
Vlan-int106
Source 2
Receiver
Host C
Receiver
Host B
IP address
192.168.1.1/24
10.110.1.1/24
192.168.2.1/24
10.110.1.2/24
10.110.2.1/24
10.110.3.1/24
192.168.3.1/24
10.110.4.1/24
10.110.5.1/24
10.110.2.2/24
10.110.6.1/24
10.110.10.1/24
10.110.6.2/24
192.168.6.1/24
10.110.10.2/24
1-46
Vlan-int500
Vlan-int109
Source 3
Vlan-int109
Vlan-int102
Vlan-int107
Switch C
Vlan-int107
ZBR
Vlan-int104
Vlan-int104
Vlan-int108
Vlan-int108
Vlan-int400
Admin-scope 2
Device Interface
Switch D Vlan-int104
Vlan-int108
Vlan-int107
Switch E Vlan-int400
Vlan-int105
Vlan-int108
Switch F Vlan-int109
Vlan-int107
Vlan-int102
Switch G Vlan-int500
Vlan-int109
Source 1 —
Source 2 —
Source 3 —
Switch G
Switch F
Switch D
ZBR
Switch E
IP address
10.110.4.2/24
10.110.7.1/24
10.110.8.1/24
192.168.4.1/24
10.110.5.2/24
10.110.7.2/24
10.110.9.1/24
10.110.8.2/24
10.110.3.2/24
192.168.5.1/24
10.110.9.2/24
192.168.2.10/24
192.168.3.10/24
192.168.5.10/24
Figure 1-12. The detailed