Configuring Multicast Source Registration - HP 4800G Series Configuration Manual

To do...
Configure a C-BSR for an
admin-scope zone
The group-address { mask | mask-length } parameter of the c-bsr group command can specify the
multicast groups the C-BSR serves, in the range of 239.0.0.0/8.
2) Configure C-BSRs for the global-scope zone
Perform the following configuration on the routers that will work as C-BSRs in the global-scope zone.
Follow these steps to configure a C-BSR for the global-scope zone:
To do...
Enter system view
Enter PIM view
Configure a C-BSR for the
global-scope zone
About the Hash mask length and C-BSR priority:
You can configure these parameters at three levels: global configuration level, global scope zone
level, and admin-scope zone level.
The value of these parameters configured at the global scope zone level or admin-scope zone level
have preference over the global values.
If you do not configure these parameters at the global scope zone level or admin-scope zone level,
the corresponding global values will be used.
For configuration of global C-BSR parameters, see

Configuring Multicast Source Registration

Within a PIM-SM domain, the source-side DR sends register messages to the RP, and these register
messages have different multicast source or group addresses. You can configure a filtering rule to filter
register messages so that the RP can serve specific multicast groups. If an (S, G) entry is denied by the
filtering rule, or the action for this entry is not defined in the filtering rule, the RP will send a register-stop
message to the DR to stop the registration process for the multicast data.
Use the command...
c-bsr group group-address
{ mask | mask-length }
[ hash-length hash-length |
priority priority ] *
Use the command...
system-view
pim
c-bsr global [ hash-length
hash-length | priority priority ] *
Configuring global C-BSR
1-26
Remarks
Required
No C-BSRs are configured for
an admin-scope zone by
default.
Remarks
—
—
Required
No C-BSRs are configured for
the global-scope zone by
default.
parameters.