Configuring Source Ipv6 Addresses Of Mld Queries; Configuring An Mld Snooping Policy; Configuration Prerequisites - HP 4800G Series Configuration Manual

To do...
Configure MLD query interval
Configure the maximum
response time for MLD general
queries
Configure the MLD
last-member query interval
Make sure that the MLD query interval is greater than the maximum response time for MLD general
queries; otherwise undesired deletion of IPv6 multicast members may occur.

Configuring Source IPv6 Addresses of MLD Queries

This configuration allows you to change the source IPv6 address of MLD queries.
Follow these steps to configure source IPv6 addresses of MLD queries:
To do...
Enter system view
Enter VLAN view
Configure the source IPv6
address of MLD general
queries
Configure the source IPv6
address of MLD
multicast-address-specific
queries
The source IPv6 address of MLD query messages may affect MLD querier election within the segment.

Configuring an MLD Snooping Policy

Configuration Prerequisites

Before configuring an MLD Snooping policy, complete the following tasks:
Enable MLD Snooping in the VLAN
Before configuring an MLD Snooping policy, prepare the following data:
Use the command...
mld-snooping query-interval
interval
mld-snooping
max-response-time interval
mld-snooping
last-listener-query-interval
interval
Use the command...
system-view
vlan vlan-id
mld-snooping general-query
source-ip { current-interface |
ipv6-address }
mld-snooping special-query
source-ip { current-interface |
ipv6-address }
1-14
Remarks
Optional
125 seconds by default
Optional
10 seconds by default
Optional
1 second by default
Remarks
—
—
Optional
FE80::02FF:FFFF:FE00:0001
by default
Optional
FE80::02FF:FFFF:FE00:0001
by default