Pim-Sm Non-Scoped Zone Configuration Example - HP 4800G Series Configuration Manual

Table of Contents

PIM-SM Non-Scoped Zone Configuration Example

Network requirements

Receivers receive VOD information through multicast. The receiver groups of different

organizations form stub networks, and one or more receiver hosts exist in each stub network. The

entire PIM-SM domain contains only one BSR.

Host A and Host C are multicast receivers in two stub networks.

Switch D connects to the network that comprises the multicast source (Source) through

VLAN-interface 300.

Switch A connects to stub network N1 through VLAN-interface 100, and to Switch D and Switch E

through VLAN-interface 101 and VLAN-interface 102 respectively.

Switch B and Switch C connect to stub network N2 through their respective VLAN-interface 200,

and to Switch E through VLAN-interface 103 and VLAN-interface 104 respectively.

Vlan-interface 105 on Switch D and Vlan-interface 102 on Switch E act as C-BSRs and C-RPs; the

C-BSR on Switch E has a higher priority; the multicast group range served by the C-RP is

225.1.1.0/24; modify the hash mask length to map a certain number of consecutive group

addresses within the range to the two C-RPs.

IGMPv2 is to run between Switch A and N1, and between Switch B/Switch C and N2.

Network diagram

Figure 1-11 Network diagram for PIM-SM non- scoped zone configuration

10.110.1.1/24

192.168.1.1/24

192.168.9.1/24

10.110.2.1/24

192.168.2.1/24

10.110.2.2/24

192.168.3.1/24

10.110.5.1/24

192.168.1.2/24

192.168.4.2/24

192.168.3.2/24

192.168.2.2/24

192.168.9.2/24

192.168.4.1/24

Table of Contents