Configuring Ipv6 Pim-Dm; Ipv6 Pim-Dm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Dm - HP 4800G Series Configuration Manual

Configuring IPv6 PIM-DM

IPv6 PIM-DM Configuration Task List

Complete these tasks to configure IPv6 PIM-DM:

Enabling IPv6 PIM-DM

Enabling State-Refresh Capability

Configuring State Refresh Parameters
Configuring IPv6 PIM-DM Graft Retry Period
Configuring IPv6 PIM Common Features

Configuration Prerequisites

Before configuring IPv6 PIM-DM, complete the following task:
Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-DM, prepare the following data:
The interval between state refresh messages
Minimum time to wait before receiving a new refresh message
Hop limit value of state-refresh messages
Graft retry period
Enabling IPv6 PIM-DM
With IPv6 PIM-DM enabled, a router sends hello messages periodically to discover IPv6 PIM neighbors
and processes messages from the IPv6 PIM neighbors. When deploying an IPv6 PIM-DM domain, you
are recommended to enable IPv6 PIM-DM on all non-border interfaces of routers.
Follow these steps to enable IPv6 PIM-DM:
To do...
Enter system view
Enable IPv6 multicast routing
Enter interface view
Enable IPv6 PIM-DM
Task
Use the command...
system-view
multicast ipv6 routing-enable
interface interface-type
interface-number
pim ipv6 dm
1-14
Remarks
Required
Optional
Optional
Optional
Optional
Remarks
—
Required
Disable by default
—
Required
Disabled by default