HP 4800G Series Configuration Manual page 753

Figure 1-2 Network diagram for IPv6 policy routing configuration
Configuration procedure
# Configure IPv6 ACL 2000.
<SwitchA> system-view
[SwitchA] acl ipv6 number 2000
[SwitchA-acl6-basic-2000] rule 0 permit source any
[SwitchA-acl6-basic-2000] quit
# Define a match criterion for class a to match IPv6 ACL 2000.
[SwitchA] traffic classifier a
[SwitchA-classifier-a] if-match acl ipv6 2000
[SwitchA-classifier-a] quit
# Configure the action of redirecting traffic to the next hop 202::2 for behavior a.
[SwitchA] traffic behavior a
[SwitchA-behavior-a] redirect next-hop 202::2
[SwitchA-behavior-a] quit
# Associate class a with behavior a in QoS policy a.
[SwitchA] qos policy a
[SwitchA-qospolicy-a] classifier a behavior a
[SwitchA-qospolicy-a] quit
# Apply QoS policy a to the incoming traffic of GigabitEthernet 1/0/1.
[SwitchA] interface gigabitethernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] qos apply policy a inbound
Verification
After completing the configuration, verify that when Switch A receives packets with destination IP
address 201::2, it forwards the packets to Switch C instead of Switch B.
1-5