Configuring An Ospf Cost For An Interface; Configuring The Maximum Number Of Ospf Routes - HP 4800G Series Configuration Manual

To do...
Enter system view
Enter OSPF view
Enter area view
Configure ABR Type-3 LSA
filtering

Configuring an OSPF Cost for an Interface

You can configure an OSPF cost for an interface with one of the following two methods:
Configure the cost value in interface view.
Configure a bandwidth reference value for the interface, and OSPF computes the cost
automatically based on the bandwidth reference value: Interface OSPF cost= Bandwidth reference
value/Interface bandwidth. If the calculated cost is greater than 65535, the value of 65535 is used;
if the calculated cost is less than 1, the value of 1 is used.
If no cost is configured for an interface, OSPF computes the interface cost automatically.
Follow these steps to configure an OSPF cost for an interface:
To do...
Enter system view
Enter interface view
Configure an OSPF cost
for the interface
Follow these steps to configure a bandwidth reference value:
To do...
Enter system view
Enter OSPF view
Configure a bandwidth
reference value

Configuring the Maximum Number of OSPF Routes

Follow these steps to configure the maximum number of routes:
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
area area-id
filter { acl-number | ip-prefix
ip-prefix-name } { import | export }
Use the command...
system-view
interface interface-type
interface-number
ospf cost value
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
bandwidth-reference value
1-29
Remarks
—
—
—
Required
Not configured by
default.
Remarks
—
—
Optional
By default, an interface computes its
cost according to the bandwidth.
The cost value defaults to 0 on
loopback interfaces.
Remarks
—
—
Optional
The value defaults to
100 Mbps.