Console Port Login Configuration - HP 4800G Series Configuration Manual

Figure 2-4 Set port parameters terminal window
Turn on the switch. The user will be prompted to press the Enter key if the switch successfully
completes POST (power-on self test). The prompt (such as <4800G>) appears after the user
presses the Enter key.
You can then configure the switch or check the information about the switch by executing
commands. You can also acquire help by type the ? character. Refer to the following chapters for
information about the commands.

Console Port Login Configuration

Common Configuration
Table 2-2 lists the common configuration of Console port login.
Table 2-2 Common configuration of Console port login
Configuration
Enter system view
Enter AUX user interface view
Console (AUX
user
interface)port
configuration
system-view
user-interface aux 0
Baud rate
speed speed-value
parity { even | mark |
Check mode
none | odd | space }
Stop bits stopbits { 1 | 1.5 | 2 }
—
—
Optional
The default baud rate is 19,200
bps.
Optional
By default, the check mode of
the Console port is set to
"none", which means no check
bit.
Optional
The default stop bits of a
Console port is 1.
2-3
Description