HP 4800G Series Configuration Manual page 1482

Config Pri : 100
Preempt Mode : YES
Auth Type : NONE
Virtual IP : FE90::10
2::10
Master IP : FE90::2
# Display detailed information of the VRRP group on Switch B.
[SwitchB-Vlan-interface3] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 2
Interface : Vlan-interface2
VRID : 1
Admin Status : UP
Config Pri : 100
Preempt Mode : YES
Auth Type : NONE
Virtual IP : FE80::10
1::10
Master IP : FE80::1
Interface : Vlan-interface3
VRID : 2
Admin Status : UP
Config Pri : 110
Preempt Mode : YES
Auth Type : NONE
Virtual IP : FE90::10
2::10
Virtual MAC : 0000-5e00-0202
Master IP : FE90::2
The above information indicates that in VRRP group 1 Switch A is the master, Switch B is the backup
and hosts with the default gateway of 1::10/64 accesses the Internet through Switch A; in VRRP group
2 Switch A is the backup, Switch B is the master and hosts with the default gateway of 2::10/64
accesses the Internet through Switch B.
Multiple VRRP groups are commonly used in actual networking. In IPv6 network, to implement load
sharing among multiple VRRP groups, you need to manually configure the default gateway for hosts.
Run Pri : 100
Delay Time : 0
Adver. Timer : 100
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 100
State : Master
Run Pri : 110
Delay Time : 0
1-34