Console Port Login Configuration With Authentication Mode Being Password - HP 4800G Series Configuration Manual

Console Port Login Configuration with Authentication Mode Being
Password
Configuration Procedure
Follow these steps to perform Console port login configuration (with authentication mode being
password):
To do...
Enter system view
Enter AUX user interface
view
Configure to authenticate
users using the local
password
Set the local password
Configuration Example
Network requirements
Assume the switch is configured to allow you to login through Telnet, and your user level is set to the
administrator level (level 3). After you telnet to the switch, you need to limit the Console user at the
following aspects.
The user is authenticated against the local password when logging in through the Console port.
The local password is set to 123456 (in plain text).
The commands of level 2 are available to users logging in to the AUX user interface.
The baud rate of the Console port is 19,200 bps.
The screen can contain up to 30 lines.
The history command buffer can store up to 20 commands.
The timeout time of the AUX user interface is 6 minutes.
Use the command...
system-view
user-interface aux 0
authentication-mode
password
set authentication
password { cipher |
simple } password
2-7
Remarks
—
—
Required
By default, users logging in through the
Console port are not authenticated, while
users logging in through the Telnet need
to pass the password authentication.
Required
By default,no password is configured.