Configuring Link Monitoring; Configuring Basic Ethernet Oam Functions - HP 4800G Series Configuration Manual

Configuring Basic Ethernet OAM Functions

Configuring Link
Monitoring
Enabling OAM Remote Loopback
Configuring Basic Ethernet OAM Functions
As for Ethernet OAM connection establishment, a device can operate in active mode or passive mode.
After Ethernet OAM is enabled on an Ethernet port, according to its Ethernet OAM mode, the Ethernet
port establishes an Ethernet OAM connection with its peer port.
Follow these steps to configure basic Ethernet OAM functions:
To do...
Enter system view
Enter Ethernet port view
Set Ethernet OAM operating
mode
Enable Ethernet OAM on the
current port
To change the Ethernet OAM operating mode on an Ethernet OAM-enabled port, you need to first
disable Ethernet OAM on the port.

Configuring Link Monitoring

After Ethernet OAM connections are established, the link monitoring periods and thresholds configured
in this section take effect on all Ethernet ports automatically.
Task
Configuring Errored Symbol Event Detection
Configuring Errored Frame Event Detection
Configuring Errored Frame Period Event Detection
Configuring Errored Frame Seconds Event Detection
Use the command...
System-view
interface interface-type
interface-number
oam mode { active | passive }
oam enable
—
—
Optional
The default is active Ethernet
OAM mode.
Required
Ethernet OAM is disabled by
default.
1-6
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Remarks