Displaying And Maintaining Ethernet Oam Configuration; Ethernet Oam Configuration Example - HP 4800G Series Configuration Manual

Ethernet OAM remote loopback is available only after the Ethernet OAM connection is established
and can be performed only by the Ethernet OAM entities operating in active Ethernet OAM mode.
Remote loopback is available only on full-duplex links that support remote loopback at both ends.
Ethernet OAM Remote loopback needs the support of the peer hardware.
Enabling Ethernet OAM remote loopback interrupts data communications. After Ethernet OAM
remote loopback is disabled, all the ports involved will shut down and then come up. Ethernet OAM
remote loopback is disabled when you execute the undo oam enable command to disable
Ethernet OAM, when you execute the undo oam loopback command to disable Ethernet OAM
remote loopback, or when the Ethernet OAM connection times out.
Ethernet OAM remote loopback is only applicable to individual links. It is not applicable to link
aggregation member ports or service loopback group member ports. In addition, you cannot assign
ports where Ethernet OAM remote loopback is being performed to link aggregation groups or
service loopback groups. For more information about link aggregation groups and service loopback
groups, refer to Link Aggregation Configuration and Service Loopback Group Configuration in the
Access Volume.
Enabling internal loopback test on a port in remote loopback test can terminate the remote
loopback test. For more information about loopback test, refer to Ethernet Interface Configuration
in the Access Volume.

Displaying and Maintaining Ethernet OAM Configuration

Display global Ethernet OAM configuration
Display the statistics on critical events after
an Ethernet OAM connection is
established
Display the statistics on Ethernet OAM link
error events after an Ethernet OAM
connection is established or after you clear
the statistics
Display the information about an Ethernet
OAM connection
Clear statistics on Ethernet OAM packets
and Ethernet OAM link error events

Ethernet OAM Configuration Example

Network requirements
Enable Ethernet OAM on Device A and Device B to auto-detect link errors between the two
devices.
Monitor the performance of the link between Device A and Device B by collecting statistics about
the error frames received by Device A.
To do... Use the command...
display oam configuration
display oam critical-event [ interface
interface-type interface-number ]
display oam link-event { local | remote }
[ interface interface-type
interface-number ]
display oam { local | remote } [ interface
interface-type interface-number ]
reset oam [ interface interface-type
interface-number ]
1-9
Remarks
Available
in any
view
Available
in user
view only