Brocade Communications Systems Brocade 8/12c Command Reference Manual page 955

NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command supports the following operands:
-p
-m
EXAMPLES
To display the status of all slots on a DCX 8510-8:
To display the Brocade model name for each blade on a Brocade DCX 8510-8:
Fabric OS Command Reference
53-1001764-01
DISABLED
The blade is powered on but disabled.
FAULTY
The blade is faulty because an error was detected.
UNKNOWN
The blade is inserted but its state cannot be determined.
In addition to the basic slot status view, displays the following information about
power consumption:
•
Total direct current (DC) power consumption for the chassis and individual
values for each blade (in Watts). Note that usage for other components is
included but not listed.
•
Total alternating current (AC) power consumption in Watts.
•
AC efficiency, as a percentage of total and BTU.
•
Power efficiency in Watts/port and Watts/Gb.
In addition to the basic slot status view, displays the Brocade model name for
each blade.
switch:user> slotshow
Slot Blade Type ID
---------------------------------
1 UNKNOWN
2 AP BLADE 43
3 UNKNOWN
4 SW BLADE 97
5 CORE BLADE 98
6 CP BLADE 50
7 CP BLADE 50
8 CORE BLADE 98
9 AP BLADE 75
10 SW BLADE 97
11 SW BLADE 77
12 SW BLADE 96
switch:user> slotshow -m
Slot Blade Type
--------------------------------------------------
1 UNKNOWN
2 AP BLADE 43
3 UNKNOWN
4 SW BLADE 97
5 CORE BLADE 98
6 CP BLADE 50
Status
VACANT
ENABLED
VACANT
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ID Model Name
FS8-18
FC16-32
CR16-8
CP8
slotShow
Status
VACANT
ENABLED
VACANT
ENABLED
ENABLED
ENABLED
22
921