Training Requirements
Training Requirements
Introduction
The operator must receive training for safety issues, printer operation, and the appropriate
ONYX Workflow software (ProductionHouse® or THRIVE) prior to operating the
printer.
Safety Training
Before operating the Océ Arizona 400 Series GT printer, make sure you have read and
understood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all printer operators must have received training by
qualified Océ service personnel. Océ training provides a general orientation to printer
safety and operating procedures. This User Manual is not a substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the printer requires a properly trained operator. Océ trains
the operator in the use of the printer hardware and software at installation. However, this
is not a substitute for formal training.
Operators must be fully versed in the operation of ONYX Workflow software . For any
operator unfamiliar with their operation, ONYX ProductionHouse® or THRIVE
training is required. Training courses are available; contact your local representative for
an ONYX-certified training program.
72
Chapter 5 - How to Operate Your Océ Arizona Printer