Oce Arizona 400 Series GT User Manual page 75

How to Power Off
Attention:
To maintain optimal printer reliability, leave the power on at all times. However, there
are exceptions such as for ink flushes, some service procedures, or if the printer requires
a reboot.
If you need to shut down the printer for just a few minutes, follow this procedure.
However, if you need to leave the printer idle for periods of 30 minutes to 14 days, see
the table below.
Turn off the UV lamps.
1.
Wait for the lamps to cool down (fans will stop).
2.
Click on the Shutdown icon in the Tools and Utilities tab to exit the printer software.
3.
Turn the AC power switch to the OFF position.
4.
Turn the power back on when the service or procedure is complete.
5.
Note:
Avoid Extended Power Off
If the power is switched off for only a short period (for example, when the printer is shut
down and then immediately restarted to correct an electrical problem or other trou-
bleshooting), no special action is required at startup. However, if it is necessary to leave
the printer idle for an extended period refer to the table below. Also, perform Printhead
Maintenance and Swab the printheads when you start to use it again. We recommend
that you leave the printer powered On at all times except for maintenance or repair.
How to Prepare the Printer for Idle Periods:
Attention:
Do not turn off the printer during these idle times.
#
15 to 30 minutes
30 minutes to 24 hours
• Turn off lamps
• Turn off lamps
• Turn off ink heater
Chapter 5 - How to Operate Your Océ Arizona Printer
How to Power the Printer On and Off
75