Oce Arizona 400 Series GT User Manual page 120

How to Load Media
Tape the media onto the core. The media should have a clean straight edge prior to taping.
8.
First tape the center of the media to the core, and then tape both ends of the media.
[81] Tape Media to the Take-up Roll Core
Note:
Important: Use the supplied ruler to check that the edge of the take-up roll is aligned
within 1mm of the feed roll.
Select the "Initialize" icon from the Roll Media Manager to prepare the RMO for printing.
9.
D: Loading the Media - Alternate Method
This alternate method to load media requires a little more time and effort but it usually
provides better alignment and therefore less chance of banding in the image. When roll
media is not properly aligned, the result is overstepping on one side and understepping
on the other side of the media so that the band in the printed image is dark on one side
and light on the other. The alternate method is recommended for long print jobs where
skewing of the media can become progressively more pronounced or when using media
that has some flexibility and therefore proper alignment is hard to achieve with the standard
method.
Load the roll on the media shaft and begin the load procedure as described in steps 1 to
1.
5 in the standard method, to the point where you have advanced the media over the
platen until it lies over the bottom media feed roll.
Align the edges of the hanging media to the supply roll edges.
2.
120 Chapter 7 - How to Operate the Roll Media Option