How To Print On Roll Media - Oce Arizona 400 Series GT User Manual

How to Print on Roll Media

Introduction
To print an RMO image, media must be loaded and the RMO initialized. Use the Print
Job module and the Roll Media Manager to prepare and start the print job.
How to Print on Backlit Media
If your roll media is transparent or opaque and you are going to backlight the image and
you want to increase the density, set Quality mode in ProductionHouse. Then click on
the Quality parameter in the Print Job menu and select Quality-Density before you ini-
tialize the job. This mode increases the density of ink for this image as it prints and
therefore improves the appearance of backlit images.
Attention:
The red Emergency stop buttons do NOT stop the media transport when you print on
roll media (they only stop gantry and carriage movement). If you encounter a situation
where the roll media runs continuously without operator input, the only recourse is to
shut off the printer's AC power switch.
Prepare a Roll Media Print Job
Click on the Roll icon in the menu bar of the Job Control module to disable the RMO
1.
print queue (this allows you to check media parameters before the job actually prints in
case the job was not given a Hold status when it was generated in Onyx ProductionHouse).
[87] Roll Icon
In the Print Job Control module, transfer a print job from the ONYX Workflow software.
2.
Chapter 7 - How to Operate the Roll Media Option
How to Print on Roll Media
127