Oce Arizona 400 Series GT User Manual page 103

Enter 2 or more copies in the Job Parameters Copies field.
2.
Click on the Enable Dual Origin box when it appears to make it active.
3.
Note:
When Dual origins is enabled, a scaled view of the image appears on the screen preview
in Zone A and a gray-scale box that represents the image appears in Zone B. Both images
are displayed at their respective origin points. If you move the primary image in Zone A
to a new origin (or enter new offsets), both images will then print from that changed
relative origin point.
Place media in Zone A, mask off any unused areas, and then turn On the vacuum.
4.
Press the Start button to begin the print in Zone A.
5.
Place media in Zone B, mask off any unused areas, and turn On the vacuum. The
6.
printer will pause over the Center Zone after the Zone A print is complete and then start
to print in Zone B.
Note:
The printer will not print in Zone B if the vacuum is not On. It will display "Waiting
for Table Vacuum" and wait in the Center Zone until the vacuum is On and then will
also require that you press the Start button. The vacuum must be cycled Off and then
On again in alternating zones before the next print will begin while Dual Origin is enabled.
If additional copies of the print were indicated in Step 2, then repeat Steps 5 to 7 (in al-
7.
ternate zones) for the total number of prints required.
Chapter 6 - How to Operate the Océ Arizona 400 Series XT
How to Print With Dual Origins
103