Oce Arizona 400 Series GT User Manual page 202

Arizona Printer Inks
coolant fluid through the printheads. An internal thermostat on each printhead provides
temperature feedback.
The condition of the printheads is maintained by periodic cleaning at the maintenance
station on the gantry. During this procedure the operator suctions the printhead nozzle
plates, removing ink and possible contaminates in the process (details of this procedure
are available in the Maintenance section).
Caution:
Uncured ink is a serious health and safety risk! Avoid skin contact with ink and wear
safety glasses with side shields and Nitrile rubber gloves when handling ink.
Attention:
Do not install inks that are not certified by Océ Display Graphics Systems for use in this
printer, as this may result in poor quality prints, uncured ink in the finished prints and
permanent damage to the ink pumps, filters, ink lines or printheads.
Note:
The UV lamp power settings can be lowered to reduce warping of some media. However,
set the lamp power as high as possible for each media to ensure that the ink cures prop-
erly. This will minimize the risk of skin irritation and sensitization from exposure to
uncured ink. Wear nitrile gloves when you handle printed media if you suspect the ink
is not properly cured.
Illustration
[150] Ink Bags in the Ink Bays (Primary and Secondary)
202 Chapter 10 - Ink System Management