Training Requirements - Oce Arizona 365 GT User Manual

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety, printer operation, and the appropriate ONYX
Workflow software (ProductionHouse® or THRIVE) prior to operating the Océ Arizona 365 GT
printer.
Safety Training
Before operating the Océ Arizona 365 GT printer, make sure you have read and understood all of
Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all Océ Arizona 365 GT printer operators must have received
training by qualified Océ service personnel. Océ training provides a general orientation to printer
safety and operating procedures. This User Manual is not a substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the printer requires a properly trained operator. Océ trains the
operator in the use of the printer hardware and software at installation. However, this is not a
substitute for formal ProductionHouse® or PosterShop training.
Operators of the Océ Arizona 365 GT should be fully versed in the operation of ONYX Workflow
software . For any operator unfamiliar with its operation, Onyx ProductionHouse® or THRIVE
training is required. Training courses are available; contact your local representative for an
ONYX-certified training program.
NOTE
PosterShop is not capable of producing profiles for color management with this printer and also
does not have the layout editor capabilities of ProductionHouse or Thrive.
62 Chapter 5 - How to Operate Your Océ Arizona Printer