How To Unload And Cut Media - Oce Arizona 400 Series GT User Manual

How to Unload and Cut Media

Introduction
This section explains all of the actions associated with how to cut and unload media when
there is still some media left on the supply roll.
Unload Media Summary
The following actions are associated with unloading media:
• A) Initiate Unloading
• B) Cut the Media
• C) Remove Media from Take-up Shaft in Printer or Remove Take-up Shaft
• D) Remove Supply Shaft From Printer
• E) Remove Media Roll Or Empty Core From Media Shaft
Before you begin
Note:
When you select the Unload icon the media will advance automatically by a preset
amount. This distance is determined by the Move Media on Unload value in the Settings
Roll Module tab. The default value will advance the media to a position past the Media
Cut Guide so that the printed image is not cut. To manually increase this distance you
can use the foot pedal to advance the media, but only before the Unload is selected.
Once Unload is selected the foot pedals will not work until you Initiate a new RMO
pint job.
Required tool
• 5mm hex key
A: Initiate Unloading
Click on the Roll Manager icon to bring up the Roll Media Manager.
1.
Select the Unload icon in the Roll Media Manager to release the tension.
2.
B: Cut the Media
Cut the media using the cutter guide.
1.
Chapter 7 - How to Operate the Roll Media Option
How to Unload and Cut Media
123