How to Load Media
When to do
This section explains how to load new media when none is currently loaded. If media is
already loaded, first read the section How to Cut and Unload Media.
Before you begin
It is very important that the media is wound properly onto the core when it arrives from
the manufacturer. The media must be wound straight, tight and even from one end to
the other. If you have a roll that is not even, before loading it, hold the roll in a vertical
position and carefully and evenly drop one end onto the floor, then tap lightly a few
times. If any edges are crushed, unwind and throw away the crushed area or cut off the
crushed end of roll. If is not possible to repair, do not use it.
Note:
If media has been stored on its side and has a pronounced flat side, do not use it as it
will not advance evenly.
Required tool
•
5mm hex key
114
Chapter 7 - How to Operate the Roll Media Option