Training Requirements - Oce Arizona 200 GT User Manual

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety, printer operation, and ProductionHouse®
software prior to operating the Océ Arizona 200/250/300/350 GT printer.
Safety Training
Before operating the Océ Arizona 200/250/300/350 GT printer, make sure you have
read and understood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all Océ Arizona 200/250/300/350 GT printer oper-
ators must have received training by qualified Océ service personnel. Océ training provides
a general orientation to printer safety and operating procedures. This User Manual is not
a substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the Océ Arizona 200/250/300/350 GT printer requires a
properly trained operator. Océ trains the operator in the use of the printer hardware and
software at installation. However, this is not a substitute for formal ProductionHouse®
training.
Operators of the Océ Arizona 200/250/300/350 GT should be fully versed in the operation
of Onyx ProductionHouse® . For any operator unfamiliar with its operation, Onyx
ProductionHouse® training is required. Training courses are available; contact your local
representative for an Onyx-certified training program.
Note:
PosterShop is not capable of producing profiles for color management with the Océ
Arizona 200/250/300/350 GT and also does not have the layout editor capabilities of
ProductionHouse. Also, if you use PosterShop the Océ Arizona 200/250/300/350 GT
printer driver must be purchased (it is included at no cost with ProductionHouse).
Therefore we recommend that customers not use PosterShop with this printer.
84 Chapter 5 - How to Operate the Océ Arizona 200/250/300/350 GT