Training Requirements - Oce Arizona 250 GT User Manual

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety, printer operation, and
ProductionHouse
Safety Training
Before operating the Arizona 250 GT printer, make sure you have read and
understood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all Arizona 250 GT printer operators must have
received training by qualified Océ service personnel. Océ training provides a general
orientation to printer safety and operating procedures. This User Manual is not a
substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the Arizona 250 GT printer requires a properly trained
operator. Océ trains the operator in the use of the printer hardware and software at
installation. However, this is not a substitute for formal ProductionHouse
Operators of the Arizona 250 GT should be fully versed in the operation of Onyx
ProductionHouse
ProductionHouse
local representative for an Onyx-certified training program.
Note: PosterShop is not capable of producing profiles for color management with
the Arizona 250 GT and also does not have the layout editor capabilities of
ProductionHouse. Also, if you use PosterShop the Arizona 250 GT printer driver
must be purchased (it is included at no cost with ProductionHouse). Therefore we
recommend that customers not use PosterShop with this printer.
72 Chapter 5 How to Operate the Arizona 250 GT

software prior to operating the Arizona 250 GT printer.

. For any operator unfamiliar with its operation, Onyx

training is required. Training courses are available; contact your

training.