Oce Arizona 400 Series GT User Manual page 116

How to Load Media
Accurately center the media using the supplied ruler. Media should be centered within
5.
1mm on the ruler.
[77] Ruler to Center Media
Note:
The supplied ruler has both metric (millimeters) and imperial (inches) scales. When a
media roll is centered on the shaft, and the ruler is placed as shown in the photo, the
value on the ruler scale will match the width of the roll. For example, in the photo a 2
meter (or 2000mm) roll is centered on the media shaft.
Lock the supply media shaft core locks by turning the 5mm hex key clock-wise.
6.
Re-check that the media is still centered as locking the core may cause the roll to shift
7.
(usually the shift is from 1 to 2 milimeters to the right).
B: Load an Empty Core and Install in the Take-up Position
Place the empty take-up media shaft on a suitable work surface and unlock the media
1.
shaft locks with the 5mm hex key.
Slide an empty media core that is at least as long as the supply media width onto the take-
2.
up shaft.
Roughly center the core and then insert the shaft into the Take-up (top) position on the
3.
RMO unit.
116 Chapter 7 - How to Operate the Roll Media Option