Oce Arizona 400 Series GT User Manual page 52

Print Job Control Module
Ink Tempera-
ture Control
UV Curing
Lamp Control
Table vacuum
Start
52 Chapter 4 - How to Navigate the User Interface
This icon controls the ink heater and also displays the ink temper-
ature. The state of the button reflects the status of the ink heater.
The heater times out after two hours of inactivity (time can be
changed up to four hours by a service technician). If the ink heater
is turned off when the timeout period has expired, the button
changes its status to unchecked.
The print heads must be at operating temperature (47°C / 116°F)
before a job will start printing.
Note:
If this button is flashing, it indicates an error. Click on the
Ink Status button to check the ink system.
This icon controls the UV curing lamps. The state of the button
reflects the state of the lamps. The UV lamps will timeout after 15
minutes of inactivity (time can be changed by a service technician).
If lamps are extinguished when the timeout expired, then the button
changes its status to unchecked. If lamps are off before the print
starts, then lamps are turned on automatically and the button would
reflect the state accordingly.
This button controls the table vacuum and duplicates the function
of the table vacuum foot switch. The button reflects the actual state
of the table vacuum. There is an automatic timeout that will turn
the table vacuum off. The actual time is set in the Settings module
under Printer.
Note:
Once turned off, vacuum cannot be turned on again for
approximately 5 seconds.
This icon can be used to start a flatbed print job (same function as
the physical button on the table).