Training Requirements - Oce Arizona 200 GT User Manual

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety, printer operation, and
ProductionHouse software prior to operating the Arizona 200/250 GT printer.
Safety Training
Before operating the Arizona 200/250 GT printer, make sure you have read and
understood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all Arizona 200/250 GT printer operators must
have received training by qualified Océ service personnel. Océ training provides a
general orientation to printer safety and operating procedures. This User Manual is
not a substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the Arizona 200/250 GT printer requires a properly
trained operator. Océ trains the operator in the use of the printer hardware and
software at installation. However, this is not a substitute for formal
ProductionHouse training.
Operators of the Arizona 200/250 GT should be fully versed in the operation of
Onyx ProductionHouse . For any operator unfamiliar with its operation, Onyx
ProductionHouse training is required. Training courses are available; contact your
local representative for an Onyx-certified training program.
Note: PosterShop is not capable of producing profiles for color management with
the Arizona 200/250 GT and also does not have the layout editor capabilities of
ProductionHouse. Also, if you use PosterShop the Arizona 200/250 GT printer
driver must be purchased (it is included at no cost with ProductionHouse). Therefore
we recommend that customers not use PosterShop with this printer.
74 Chapter 5 How to Operate the Arizona 200/250 GT