Training Requirements - Oce Arizona 550 GT User Manual

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety, printer operation, and ProductionHouse®
software prior to operating the Océ Arizona 550 GT printer.
Safety Training
Before operating the Océ Arizona 550 GT printer, make sure you have read and under-
stood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all Océ Arizona 550 GT printer operators must have
received training by qualified Océ service personnel. Océ training provides a general ori-
entation to printer safety and operating procedures. This User Manual is not a substitute
for official training.
Onyx ProductionHouse Training
Maximum performance from the Océ Arizona 550 GT printer requires a properly trained
operator. Océ trains the operator in the use of the printer hardware and software at instal-
lation. However, this is not a substitute for formal ProductionHouse® training.
Operators of the Océ Arizona 550 GT should be fully versed in the operation of Onyx
ProductionHouse® . For any operator unfamiliar with its operation, Onyx Production-
House® training is required. Training courses are available; contact your local represen-
tative for an Onyx-certified training program.
Note:
PosterShop is not capable of producing profiles for color management with the Océ
Arizona 550 GT and also does not have the layout editor capabilities of ProductionHouse.
Also, if you use PosterShop the Océ Arizona 550 GT printer driver must be purchased
(it is included at no cost with ProductionHouse). Therefore we recommend that cus-
tomers not use PosterShop with this printer.
72 Chapter 5 - How to Operate the Océ Arizona 550 GT