How To Configure Onyx Software For White Ink And Varnish - Oce Arizona 400 Series GT User Manual

How to Configure ONYX Software for White Ink and Varnish

How to Configure ONYX Software for White Ink and Varnish
Introduction
This section describes how to configure ONYX software (either ProductionHouse or
THRIVE) to recognize white ink or varnish workflow elements and thus allow you to
apply the approach that is best for your print job application. In order for the ONYX
software to successfully address white ink or varnish workflow data, there are options in
the software that must be configured.
Note:
Step 1 and 2 below are required for ProductionHouse only. Step 3 is needed for both
ProductionHouse and THRIVE.
How to Configure ONYX software
Within Rip-Queue, access the Configure Rip Options Palette.
1.
[98] Set up Onyx RIP
Once here, ensure that Overprint is turned on (checked).
2.
150 Chapter 9 - How to Work With White Ink and Varnish