Oce Arizona 400 Series GT User Manual page 117

Note:
Make sure that the core lock and coupler end of the shaft are on the right side of the
printer.
Lock the take-up media shaft core locks with the 5mm hex key.
4.
C: Loading the Media - Standard Method
The standard way to load media is quick and efficient and ensures minimum waste of
material. However, for some longer print jobs or when you use media that is more flexible
and therefore harder to achieve good alignment, there is an alternate method that will be
described in Section D. Straight loading of roll media is very important to avoid wrinkles
and banding in the print, especially on longer print job runs. If you want to ensure that
a media is loaded straight or if you see an inverted light/dark banding across the media,
we recommend the alternative method.
Select the Load icon from the Roll Media Manager.
1.
If you are going to print with "Print Side In", click the icon in the Roll Media manager
2.
("Print Side Out" is the default so you do not need to select it unless you have previously
used Print Side In). Note that the icon toggles from one choice to the other when you
click it.
Note:
For Print Side Out, the media unrolls from the bottom the supply shaft.
For Print Side In, the media unrolls from the top of the supply shaft.
Wait for the gantry to move part way across the table.
3.
Chapter 7 - How to Operate the Roll Media Option
How to Load Media
117