Clean Carriage; Printhead; Clean Gantry - Oce Arizona 400 Series GT User Manual

Note:
Do not bump the carriage or gantry as this can cause dropouts in the printhead nozzles.
A hard bump can break the meniscus vacuum in the ink lines and thus allow air into
the lines, which blocks the nozzle until a purge is performed. Also some procedures,
such as Printhead Maintenance, require that you slide open the door to access the
maintenance station. Do not bang the door hard when you close it after maintenance.
The following table provides our recommended maintenance schedule. This is a minimum
requirement and some procedures may need to be done with greater frequency. Each of
the procedures is explained in detail in this section in the order of frequency required as
presented in this table.
Maintenance Frequency
Procedure
Clean Carriage Underside
Printhead Maintenance
Swab Printheads
Clean UV Lamp Filter
Remove Ink from Table
Empty the Waste Tray
Refill Coolant
Clean Gantry Rails
Change Ink Filters
Reprint the Rulers
Change both UV Lamps
Change Coolant
Maintain White Ink
#
Frequency
Daily and as needed
Daily and as needed
Weekly and as needed
Weekly and as needed
As needed
Monthly and as needed (or when ink overflows!)
Monthly and check weekly
Monthly and as needed
Yearly, or after 11 bags of ink, or if pigment looks
weak
When the rulers become unreadable
When curing is insufficient
Yearly (requires a service call)
Daily, Weekly and, as needed
Maintenance Guidelines
Chapter 12 - Printer Maintenance 213