Oce Arizona 400 Series GT User Manual page 124

How to Unload and Cut Media
Click on OK to proceed.
2.
C: Remove Media from the Take-up Shaft in Printer or Remove Take-up Shaft
If you want to remove the printed images without removing the take-up roll from the
1.
printer you can press the left pedal to rotate the take-up media shaft in the reverse direc-
tion. You can then roll up the media by hand as it comes off the take-up roll.
To remove the take-up roll without manually rolling up the media, tap the right pedal
2.
momentarily to rotate the take-up shaft one revolution to the unlocked position in the
forward direction.
D: Remove the Supply Shaft From the Printer
If you want to change the supply shaft, momentarily press the left pedal to rotate the
1.
shaft to the unlocked position.
Remove the supply shaft from the printer by pulling it towards you. Pull one end out at
2.
a time.
E: Remove Media Roll Or Empty Core From the Media Shaft
Place the media shaft on a suitable work surface.
1.
Unlock the media shaft core locks using a 5 mm hex key.
2.
Slide the media core off the shaft.
3.
124 Chapter 7 - How to Operate the Roll Media Option